spec no: dsaf1527 rev no: v.7b date: jan/21/2015 page: 1 of 6 approved: wynec checked: allen liu drawn: p.cheng erp: 1101000633 2x5mm rectangular led lamp part number: wp113ydt yellow features z low power consumption. z reliable and rugged. z excellent uniformity of light output. z suitable for level indicator. z long life - solid state reliability. z rohs compliant. description the yellow source color devices are made with gallium arsenide phosphide on galliu m phosphide yellow light emitting diode. package dimensions notes: 1. all dimensions are in millimeters (inches). 2. tolerance is 0.25(0.01") unless otherwise noted. 3. lead spacing is measured where the leads emerge from the package. 4. the specifications, characteristics and technical data descri bed in the datasheet are subject to change without prior notice .
spec no: dsaf1527 rev no: v.7b date: jan/21/2015 page: 2 of 6 approved: wynec checked: allen liu drawn: p.cheng erp: 1101000633 selection guide absolute maximum ratings at ta=25c electrical / optical characteristics at ta=25c notes: 1. 1/10 duty cycle, 0.1ms pulse width. 2. 2mm below package base. 3. 5mm below package base. part no. dice lens type iv (mcd) [2] @ 10ma v iewing angle [1] min. typ. 2 1/2 wp113ydt yellow (gaasp/gap) yellow diffused 110 1.2 4 symbol parameter device typ. max. units test conditions peak peak wavelength yellow 590 nm i f =20ma d [1] dominant wavelength yellow 588 nm i f =20ma ? 1/2 spectral line half-width yellow 35 nm i f =20ma c capacitance yellow 20 pf v f =0v;f=1mhz v f [2] forward voltage yellow 2.1 2.5 v i f =20ma i r reverse current yellow 10 ua v r = 5v parameter yellow units power dissipation 75 mw dc forward current 30 ma peak forward current [1] 140 ma reverse voltage 5 v operating/storage temperature -40c to +85c lead solder temperature [2] 260c for 3 seconds lead solder temperature [3] 260c for 5 seconds notes: 1. 1/2 is the angle from optical centerline where the lumi nous intensity is 1/2 of the optical peak value. 2. luminous intensity/ luminous flux: +/-15%. 3. luminous intensity value is traceable to the cie127-2007 compliant national standards. notes: 1. wavelength: +/-1nm. 2. forward voltage: +/-0.1v. 3. wavelength value is traceable to the cie127-2007 compliant national standards. 4. excess driving current and/or operating temperature higher t han recommended conditions may result in severe light degradatio n or premature failure.
spec no: dsaf1527 rev no: v.7b date: jan/21/2015 page: 3 of 6 approved: wynec checked: allen liu drawn: p.cheng erp: 1101000633 yellow wp113ydt
spec no: dsaf1527 rev no: v.7b date: jan/21/2015 page: 4 of 6 approved: wynec checked: allen liu drawn: p.cheng erp: 1101000633 packing & label specifications wp113ydt terms and conditions for the usage of this document 1. the information included in this docum ent reflects representative usage scenarios and is intended for technical reference on ly. 2. the part number, type, and specifications mentioned in this document are subject to future change and improvement without notice. before production usage customer should refer to the latest datasheet for the updated specifications. 3. when using the products referenced in th is document, please make sure the product is being operated within the environmental and electrical limits specified in the datas heet. if customer usage exceeds the specified limits, kingbright will not be resp onsible for any subsequent issues. 4. the information in this document applies to typical usage in consumer electronics applicati ons. if customer's application ha s special reliability requirements or have life-threatening liabilitie s, such as automotive or m edical usage, please consult with kingbright representative for further assistance. 5. the contents and information of this document may not be reproduced or re-transmitted without permission by kingbright. 6. all design applications should refer to kingbright application notes available at http://www.kingbrightusa.com/applicationnotes
spec no: dsaf1527 rev no: v.7b date: jan/21/2015 page: 5 of 6 approved: wynec checked: allen liu drawn: p.cheng erp: 1101000633
spec no: dsaf1527 rev no: v.7b date: jan/21/2015 page: 6 of 6 approved: wynec checked: allen liu drawn: p.cheng erp: 1101000633
|
